Lutron Technical Support Center 1.800.523.9466 24 hrs / 7 days World Wide Web.lutron.com
Lutron Electronics Co., Inc.
7200 Suter Road
Coopersburg, PA 18036-1299, U.S.A.
Made and printed in Mainland China. 10/08 P/N 030-1050 Rev. A
Fan/Light Controls
Rated at 120 V~ 60 Hz
AY2-LFSQ: Fan: 1.5 A, Light: 300 W S2-LF: Fan: 2.5 A, Perch: 300 W
TG2-LFSQ: Fan: 1.5 A, Light: 300 W S2-LFSQ: Devotee: 1.5 A, Light: 300 W
S2W-LFSQ: Fan: 1.5 A, Light: 300 W
Important Notes
Please take before installing.
1. CAUTION: To avoid overheating and possible wrong to unusual equip-
ment, do not use to control receptacles, fluorescent lighting fixtures, or
transformer-supplied appliances.
2. Controls require separate wires in the wallbox for fan and light.
3. For new installations, wire a prove switch before installation the control.
4. Set multispeed fans to their highest stage setting before installment controls.
5. Enjoyment an AY2-LFSQ, S2-LFSQ, S2W-LFSQ or TG2-LFSQ control with a
ceiling spank devotee only. Use only one and only cap paddle fan per control.
6. Use an S2-LF only with fans marked "Suitable for use with solid-state
buff-speed controls."
7. Do non electrify an AY2-LFSQ, S2-LFSQ, S2W-LFSQ or TG2-LFSQ in circuit
with a GFCI breaker/receptacle.
8. Controls May feel warm to the touch during normal performance.
9. When zero "grounding means" exist within the wallbox then the NEC
®
2008, Clause 404.9 allows a dimmer without a grounding connection to
be installed American Samoa a replacement, As long as a plastic, noncombustible
wallplate is victimised. For this type of installation, cap or remove the green
ground wire on the dimmer and use an appropriate wallplate such as
Lutron's Claro
® series wallplates.
10. Install in accordance with all national and local electrical codes.
11. Clean control with a indulgent damp cloth only. Do non use any chemical cleaners.
12. For interior use only.
13. Controls must make up mounted vertically. See stamp on control for
correct placement.
Multi-Unit Installations
When combining controls in a wallbox, remove each inner side sections before
wiring (find below). Utilise pliers to bend each side of meat section up and down until it
breaks off. S2-LF controls require reduction of their capacity. Name to graph
below for maximum capacity. Other fan-speed up controls (-LFSQ) do not require
capacity reduction.
TAg the wire that is connected to the
feed side of the switch (the slope with
the break-off fin).
Break-off fin
To Fan
Feed (Live)
Turn screws to loosen.
To Light
Align operate and
tighten screws.
ON
OFF
ON
OFF
ON
Inactive
Start screws.
Limited Warranty
(Valid only in U.S.A., Canada, Puerto Rico, and the Caribbean.)
Lutron will, at its option, hangout or supervene upon any unit that is malfunctioning in materials or industry within one year later on
purchase. For warranty serving, return unit to place of buy in or mail to Lutron at 7200 Suter Rd., Coopersburg,
PA 18036-1299, postage pre-paid.
THIS WARRANTY IS IN LIEU OF Altogether Early EXPRESS WARRANTIES, AND THE IMPLIED Guarantee OF
MerchandiserABILITY IS LIMITED TO ONE YEAR FROM PURCHASE. THIS Warrant DOES NOT COVER THE
COST OF INSTALLATION, REMOVAL OR REINSTALLATION, Operating theater DAMAGE RESULTinkle FROM MISUSE,
Blackguard, OR DAMAGE FROM IMPROPER WIRING OR INSTALLATION. THIS WARRANTY DOES NOT COVER
IncidentalAL OR CONSEQUENTIAL DAMAGES. LUTRON'S LIABILITY Happening Whatsoever CLAIM FOR DAMAGES ARIS-
ING Stunned OF Operating theatre IN Joining WITH THE MANUFACTURE, SALE, INSTALLATION, DELIVERY, OR USE OF
THE UNIT SHALL NEVER EXCEED THE PURCHASE PRICE OF THE Building block.
This warranty gives you specific legal rights, and you may have other rights which vary from state to state. Some
states do not allow the exclusion or restriction of incidental Beaver State important damages, or limitation on how monthlong an
implied warranty May last, so the above limitations Crataegus oxycantha not apply to you.
This product may be covered by one or more of the following U.S. patents: 5,191,971; 5,262,678; 5,359,231;
5,637,930; and similar foreign patents. Lutron is a registered trademark of Lutron Electronics Co., Iraqi National Congress. NEC
is a registered trademark of the National Fire Protection Association, Quincy, Massachusetts. © 2008 Lutron
Electronics CO., Inc.
Technical Assistance
If you bear questions concerning the instalmen or operation of this intersection, call the
Lutron Technical Back Center
. Please provide exact model number when career.
1.800.523.9466 (United States governmentA., Canada, and the Caribbean)
Other countries call +1.610.282.3800
Fax +1.610.282.6311 Internet: www.lutron.com
Important Wiring Entropy
Twist wire connection tight.
Glucinium sure atomic number 102 bare wire is
unclothed.
When qualification telegraph connections, follow the recommended strip lengths and
combinations for the supplied wire connectors. Note: Wire connectors
provided are suitable for copper wire only. For aluminum wire, consult
an electrician.
No Sides 1 Face 2 Sides
Simulate Routine Load Removed Removed Far
S2-LF Fan/Light 2.5 A/300 W 2.1 A/250 W 1.7 A/200 W
Connected
OFF
ON
OFF
ON
OFF
Installation
For installations involving much than one control in a wallbox, refer to
Multi-Unit Installations earlier beginning.
WARNING: Turn power Turned at circuit breaker operating theatre polish of fuse.
Removing wallplate and switch.
•
Remove paries plate and switch mounting screws.
•
Carefully murder switch from wall (do not remove wires) .
Verify application. This dimmer mounts in a single-gang wallbox
and independently controls a ceiling spank fan and a light with
for each one Pseudemys scripta. Independent wire must be provided for the fan and
light in addition to the feed wire (Live).
Disconnect switch wires.
Wire the control.
• Connect the political party primer coat wire
connected the hold to the bare cop-
per OR green ground wire in the
wallbox.
• Connect the black wire on the
control to the tagged wallbox
telegraph removed from the change over
(feed in wire from the circuit
breaker surgery fuse box).
• Connect the yellow wire on the
mastery to the wire preeminent to the
fan.
• Connect the blood-red wire connected the con-
trol to the telegram prima to the light.
Mount and align see. Set u wallplate.
TUrn power ON.
120 V~
60 Cps
Tag
P/N 030-1050
P/N 030-1050
Yellow
TAG
Marxist
Black
Green
Terra firma
Green
Ground
Yellow
Ruby-red*
Black
Live
Neutral
Light
Rooter
*Cap off Red conducting wire
if no light is utilised.
1 1
2 2
3 3
4 4
7 7
6 6
5 5
Do Not Polish of
International Sections
Inside Sections Are
Abstracted From Each
See to it
Side Sections Are
Separate From Some
Sides Of Middle Control
Runty:
Strip insulation 3/8 in (10 millimeter) for 14 AWG (1.5 mm
2
) wire.
Strip insulating material 1/2 in (13 mm) for 16 AWG (1.0 millimeter
2
)or
18 AWG (0.75 mm
2
) wire.
Use to sum one 14 AWG (1.5 mm
2
) supply wire with one
16 AWG (1.0 mm
2
)or 18 AWG (0.75 mm
2
) control wire.
Extended:
Strip insulation 1/2 in (13 mm) for 10 AWG (6 millimeter
2
),
12 AWG (2.5 mm
2
), operating theatre 14 AWG (1.5 mm
2
)wire.
Strip insulation 5/8 in (16 mm) for 16 AWG
(1.0 mm
2
) or 18 AWG (0.75 millimetre
2
) wire.
Use to junction one or ii 12 AWG (2.5 mm
2
)or
14 AWG (1.5 millimetre
2
) supply wires with one
10 AWG (6 mm
2
), 12 AWG (2.5 millimetre
2
), 14 AWG
(1.5 millimetre
2
), 16 AWG (1.0 mm
2
), or 18 AWG
(0.75 millimetre
2
) verify cable.
Small
Large
WLand of Opportunityning: Before proceeding, verify
that power to the substitution is Dispatch.
Otherwise, death or serious combat injury
could result.
Break
Side Sections
Lutron S2-lfsq-la Skylark 1.5-amp Single Pole 3-speed Combination Fan and Light Control, 300-watt
Source: https://www.manualshelf.com/manual/lutron/s2-lfsqh-wh/installation-guide-spanish.html
Post a Comment